Product specifications and characteristics:

Current feedback characteristics:

On the basis of the former PID control and current feedback control, the peak current waveform control mode is added. According to the change of power supply voltage and heating, it can provide stable welding current according to the change of workpiece attachment.

1、255 kinds of welding conditions

The number of welding conditions has been expanded to 255. Corresponding to a small number of varieties of u-terminal welding conditions switch.

For example, when U-shaped terminals of 12 terminals brushless motor coil are welded, the welding conditions of 12 terminals are set respectively. Even 12 conditions can be set for the number of motors, xn sets of welding conditions. In addition, the 1st, 2nd and 3rd power on settings can be operated on the same screen.

2、Trigger stop power on function（ACT STOP）

The final dimension of u-terminal welding is an important quality management element.

Excessive welding will cause wire breakage, and insufficient welding may lead to poor conduction and unreliable possibility.

With this function, when the set welding size is reached, the welding is ended by forcing the power off through the act stop signal.

Excessive welding will cause wire breakage, and insufficient welding may lead to poor conduction and unreliable possibility.

With this function, when the set welding size is reached, the welding is ended by forcing the power off through the act stop signal.

After the "ACT STOP" signal is input, the power on and stop time can be realized within 1ms. This can ensure a very stable u-terminal welding.

3、Multi pulse function

The power on time and output (e.g. current value) of products from other companies are pulse functions that are performed in a fixed value state.

This product has its own program, up to 24 sections of power on, all power on time and output can be set arbitrarily.

This function is aimed at the U-shaped terminal welding with poor thermal balance between terminals and lines (for example, the wire is very thick and the terminal is thin), and the non fusing terminal can be set to get the most suitable heat welding.

4、Regional input control function

According to the  "CAUTION"  input "+: addition -: traction" of the judgment results of displacement and temperature, the next power on output value can be increased or decreased at any stage.

It can correspond to the change of actual welding condition. For example, the hot pressing method without TC temperature feedback can also realize temperature management. But it needs PLC control.

5、Dust control enhancement

Change the way to attract dust.

Reduce the bad action caused by dust attraction on the work site.

Spare parts for special filter membrane.

6、Input and output signal detection function

The status of I / O can be confirmed offline.

Forced ON/OFF output signal can greatly shorten the wiring confirmation time during equipment installation and maintenance.

7、Pulse width monitoring function

According to the display function of average value of high frequency output (PWN width) when power on, the margin of "welding power supply + welding transformer" reaching the maximum output and the over and insufficient condition of secondary voltage of welding transformer can be mastered. In addition, it can also confirm the deterioration state of the power circuit, set the upper and lower limits of the measured value and alarm output, and have corresponding preventive measures.

8、Water cooled welding transformer with high utilization rate

The standard configuration includes forced air cooling and water cooling.

In the water-cooled state, the U-type terminal and other welding can achieve high utilization rate.